Shop fox W1835 Spécifications télécharger pdf (Page 17)

-15-

Model W1835 (For Machines Mfg. Since 12/12)

SETUP

Recommended CFM at Dust Port: ................ 100 CFM

Do not confuse this CFM recommendation with the rating

of the dust collector. To determine the CFM at the

dust port, you must take into account many variables,

including the CFM rating of the dust collector, the length

of hose between the dust collector and the tool, the

amount of branches or Y's, and the amount of other open

lines throughout the system. Explaining this calculation

is beyond the scope of this manual. If you are unsure of

your system, consult an expert or purchase a good dust

collection "how-to" book.

To connect a dust collection hose do these steps:

1. Fit the 1

⁄2" dust hose over the dust port (see

Figure 8), and secure in place with a hose clamp.

2. Tug the hose to make sure it does not come off.

Note: A tight fit is necessary for proper

performance.

Dust Collection

Figure 8. Dust port location.

Dust

Port

This tool creates substantial amounts

of dust during operation. Breathing

airborne dust on a regular basis

can result in permanent respiratory

illness. Reduce your risk by wearing a

respirator and capturing the dust with

a dust collection system.

D4363—Accessory Pack for W1835

A. Rail Track Connector ......................................1

B. Stabilizer ....................................................1

C. Adjustable Stop ............................................1

D. F-Clamps ....................................................2

Figure 6. D4363 Accessories Pack.

Figure 7. D4364 48-Tooth Blade.

D4364—48-Tooth Blade for W1835 Saw

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 35 36

Pas de commentaire

Shop fox W1835 Spécifications Page 17