Shop fox W1835 Spécifications télécharger pdf (Page 25)

-23-

Model W1835 (For Machines Mfg. Since 12/12)

OPERATIONS

Additional rail tracks (sold separately) can be joined with

the rail track connector. To connect multiple tracks,

insert the connector into the inner grooves of each rail

track (see Figure 23). Flip the rail tracks over and slide

the tracks together so that the connector is equally-

distributed. Tighten the connector set screws into place

with a hex wrench.

Figure 24. Adjustable stop on rail track.

Adjustable Stop

The adjustable stop (see Figure 24) attaches to the rail

track and is positioned in front of the saw body. The

adjustable stop fits on the outer rail of the rail track

and provides a stable stopping point along the rail track,

which is especially useful when making plunge cuts.

The stabilizer (see Figure 25) clips the saw onto the rail

track to help prevent the saw from accidentally derailing.

The stabilizer is attached to the base plate.

To position the stabilizer against the rail track, loosen

the thumb screw and adjust the outer lip of the stabilizer

around the outside of the rail track, as shown in Figure

26. Retighten the thumb screw once the stabilizer lip is in

place.

When not in use, remove the stabilizer from the saw base

plate. The stabilizer rests slightly lower than the saw

base plate and could affect the angle of the blade to the

workpiece when not attached to the rail track.

Figure 25. Stabilizer clipped over rail

track.

Base Plate

Rail Track

Stabilizer

Figure 23. Joining two rail tracks.

Connector

Additional

Rail Track

Figure 26. Stabilizer on rail track.

Stabilizer

Adding Rail Tracks

Using Adjustable Stop

Using the Stabilizer

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 35 36

Pas de commentaire

Shop fox W1835 Spécifications Page 25