Shop fox W1835 Spécifications télécharger pdf (Page 22)

-20-

Model W1835 (For Machines Mfg. Since 12/12)

OPERATIONS

There are generally two types of cuts made with this

saw—straight cuts and plunge cuts.

Straight cuts are made with the blade already extended,

with the cut beginning on one edge of the workpiece and

ending on the opposite side. These cuts work well for

cutting objects into separate pieces and for straight-lining

rough lumber.

To make basic straight cuts, do these steps:

1. Set the depth of cut (as described in the Setting

Cutting Depth section on Page 21).

2. Position the front of the saw onto the workpiece,

leaving enough room for the blade to fully extend

from the bottom without coming into contact with

the workpiece, as shown in Figure 17.

3. Hold the saw firmly with one hand on each handle,

as shown in Figure 18.

4. Engage the plunge release and extend the blade.

To activate the saw, pull the power trigger while

holding the plunge release.

Note: Holding the power trigger alone will not

activate the saw. For power to be activated, both

the plunge release and the power trigger must be

pressed. After power has been activated, the plunge

release can be disengaged.

5. Move the saw forward over the workpiece in an

even, steady motion.

6. When finished, release the power trigger and allow

the blade to come to a complete stop. Return the

saw to its upright position by lifting up on the

handle, allowing the blade to retract and the saw to

lock in place.

Workpiece

Figure 17. Positioning the saw onto the

workpiece for a straight cut.

Figure 18. Proper hand positions.

Let the saw reach full speed before

contacting the workpiece. Doing so

will reduce the risk of kickback, help

provide the cleanest cut, and reduce

stress on the saw motor.

Keep fingers and hands away from

the saw blade and out of blade path

during operation. Use clamps to hold

the workpiece in place if needed.

Making Straight Cuts

Eye injury hazard! Always wear safety

glasses when using this machine.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Shop fox W1835 Spécifications Page 22

Commentaires sur ces manuels